PMS Steps

Modified on Tue, Sep 27, 2022 at 11:15 AM

FTM-400 / PMS StepsThis is what I found with the FTM-400 and PMS scanning.

Using programmer version 5.00.47, I set frequencies in the Band A and Band B Limit Memories. I also set Step to 5, 25, 12.5, 50, 100, and Auto.

What I found once I sent the file to the radio.

  1. I could check the steps two ways....
    • put the radio into memory mode / select a PL channel / start scanning / touch SCAN again to stop scanning / verify that PMS appears on the screen just above and to the left of the frequency / turn the tuning knob for a or B band and watch the frequencies change based on the step.
    • select the upper or lower channel / press and hold Setup to enter the Set Menu / select Config / select 7 FM Am Step / the step is displayed there (this is interesting especially when Step is set to Auto in the program. The radio automatically selects a value for this field.)

  2. If the step on the upper and lower limit were different, the radio scanned based on whether I started scanning on the upper or lower channel.

  3. I could get each of the steps to work. I verified each both ways I described above.
08/26/2020

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons

Feedback sent

We appreciate your effort and will try to fix the article