When programming channels into the DR memories, they must have a call sign associated with RPT1 and RPT2 and be set to DV mode to show up in the Gateway CQ section of the "TO" list (Incoming signal) on the radio. While they are set up for other uses and can be used in the Repeater List of the "FROM" selection (outgoing signal), they are not a part of the "To" operations.
This channel will show up in both the To and From selections when making that choice from the face of the radio.
Remember too, you can update the DR Memories list and remove those repeaters you won't be using with the DSTAR calculator that is built right into the programmer.
This channel will show up in both the To and From selections when making that choice from the face of the radio.
Remember too, you can update the DR Memories list and remove those repeaters you won't be using with the DSTAR calculator that is built right into the programmer.
DSTAR, DR Memories 01/06/2020 01:47PM
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article