Call sign setup for FTM-100

Modified on Fri, Jul 7, 2023 at 2:59 PM

Call sign setup for FTM-100
Sometimes when programming the radio an error occurs and the radio resets. When this happens, your call sign is lost along with all other settings you have changed on the radio.

To get started again for programming, you will need to enter your call sign (or at least a letter or two) for the radio to even power back on. This is done from the face of the radio.

When the radio powers up, you will receive a message to enter your callsign. Turn the right [DIAL] to the letter you want and press the right arrow [GM] key to advance to the next letter to enter.
When finished, press the [DISP] key on the radio The radio will cycle off and back on with your entry displayed on the startup screen.

In the programmer, check the Settings screen behind the frequency file that you are using to be sure you call sign is entered. Go to Settings | Radio Menu Settings to find that option.
The Settings screen opens


If the box is blank, type your call sign in here and save this file. Do File | Save from the commands on this screen to make this permanent in the programmer. Then no matter how many frequency files you make, you have this covered.





Call sign, callsign in FTM-100.08/31/2019 10:41AM

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons

Feedback sent

We appreciate your effort and will try to fix the article